{"status":"ok","message-type":"work","message-version":"1.0.0","message":{"indexed":{"date-parts":[[2026,5,4]],"date-time":"2026-05-04T20:41:11Z","timestamp":1777927271497,"version":"3.51.4"},"reference-count":43,"publisher":"SAGE Publications","issue":"9","license":[{"start":{"date-parts":[[2020,7,15]],"date-time":"2020-07-15T00:00:00Z","timestamp":1594771200000},"content-version":"tdm","delay-in-days":0,"URL":"https:\/\/journals.sagepub.com\/page\/policies\/text-and-data-mining-license"}],"content-domain":{"domain":["journals.sagepub.com"],"crossmark-restriction":true},"short-container-title":["Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering"],"published-print":{"date-parts":[[2020,10]]},"abstract":"<jats:p>A novel four-phase 16\/10 belt-driven starter generator segmented switched reluctance motor has been proposed in a previous work to reduce torque ripple and increase the fault tolerance ability. Based on the previous research, the segmented switched reluctance motor digital control system is designed and presented. The digital control system including a power converter, detection circuits, and protection circuits is introduced in detail. For detection circuits, the half-detection method is employed to decrease the cost of the system. In addition, based on MicroAutoBox DS1401, a rapid control prototype platform is established. With this software system, it is easy to transfer control models and realize real-time control directly. Then, the speed closed closed-loop control for the segmented switched reluctance motor is applied to verify the proposed system. It contains current chopper control at a low speed and angle position control at a high speed. The simulation results are given, including the flux, current, torque, and efficiency range over the entire speed range of the segmented switched reluctance motor. Finally, the experimental results are presented to verify the simulation results and the effectiveness of the system. It can be found that the simulation and experimental results are consistent and acceptable, which means that the proposed digital system can operate naturally and accurately under speed closed loop control. Hence, the proposed digital system has high compatibility and practicability.<\/jats:p>","DOI":"10.1177\/0959651820938945","type":"journal-article","created":{"date-parts":[[2020,7,15]],"date-time":"2020-07-15T08:13:49Z","timestamp":1594800829000},"page":"975-984","update-policy":"https:\/\/doi.org\/10.1177\/sage-journals-update-policy","source":"Crossref","is-referenced-by-count":3,"title":["Development of a digital control system for a belt-driven starter generator segmented switched reluctance motor for hybrid electric vehicles"],"prefix":"10.1177","volume":"234","author":[{"given":"Long","family":"Chen","sequence":"first","affiliation":[{"name":"Automotive Engineering Research Institute, Jiangsu University, Zhenjiang, China"}]},{"given":"Haoxiang","family":"Wang","sequence":"additional","affiliation":[{"name":"Automotive Engineering Research Institute, Jiangsu University, Zhenjiang, China"}]},{"ORCID":"https:\/\/orcid.org\/0000-0002-9451-3311","authenticated-orcid":false,"given":"Xiaodong","family":"Sun","sequence":"additional","affiliation":[{"name":"Automotive Engineering Research Institute, Jiangsu University, Zhenjiang, China"}]},{"given":"Yingfeng","family":"Cai","sequence":"additional","affiliation":[{"name":"Automotive Engineering Research Institute, Jiangsu University, Zhenjiang, China"}]},{"given":"Ke","family":"Li","sequence":"additional","affiliation":[{"name":"School of Electrical and Information Engineering, Jiangsu University, Zhenjiang, China"}]},{"given":"Kaikai","family":"Diao","sequence":"additional","affiliation":[{"name":"Automotive Engineering Research Institute, Jiangsu University, Zhenjiang, China"}]},{"given":"Jiangling","family":"Wu","sequence":"additional","affiliation":[{"name":"Automotive Engineering Research Institute, Jiangsu University, Zhenjiang, China"}]}],"member":"179","published-online":{"date-parts":[[2020,7,15]]},"reference":[{"issue":"3","key":"e_1_3_2_2_2","first-page":"0601505","article-title":"Performance improvement of torque and suspension force for a novel five-phase BFSPM machine for flywheel energy storage systems","volume":"29","author":"Sun X","year":"2019","unstructured":"Sun X, Jin Z, Wang S, et al. Performance improvement of torque and suspension force for a novel five-phase BFSPM machine for flywheel energy storage systems. IEEE T Appl Supercon 2019; 29(3): 0601505.","journal-title":"IEEE T Appl Supercon"},{"issue":"3","key":"e_1_3_2_3_2","first-page":"0600305","article-title":"Torque analysis and dynamic performance improvement of a PMSM for EVs by skew angle optimization","volume":"29","author":"Shi Z","year":"2019","unstructured":"Shi Z, Sun X, Cai Y, et al. Torque analysis and dynamic performance improvement of a PMSM for EVs by skew angle optimization. IEEE T Appl Supercon 2019; 29(3): 0600305.","journal-title":"IEEE T Appl Supercon"},{"key":"e_1_3_2_4_2","doi-asserted-by":"publisher","DOI":"10.1109\/TMAG.2017.2751257"},{"key":"e_1_3_2_5_2","doi-asserted-by":"publisher","DOI":"10.1109\/TEC.2020.2989438."},{"key":"e_1_3_2_6_2","doi-asserted-by":"publisher","DOI":"10.1177\/0959651818782277"},{"key":"e_1_3_2_7_2","doi-asserted-by":"publisher","DOI":"10.1109\/JESTPE.2019.2950085"},{"key":"e_1_3_2_8_2","doi-asserted-by":"publisher","DOI":"10.3233\/JAE-170112"},{"key":"e_1_3_2_9_2","doi-asserted-by":"publisher","DOI":"10.1109\/TVT.2019.2939794"},{"key":"e_1_3_2_10_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIA.2017.2687406"},{"key":"e_1_3_2_11_2","doi-asserted-by":"publisher","DOI":"10.4283\/JMAG.2016.21.3.393"},{"key":"e_1_3_2_12_2","doi-asserted-by":"crossref","unstructured":"Prucka Michael J. Development of an engine stop\/start at idle system. SAE technical paper 2005-01-0069 2005.","DOI":"10.4271\/2005-01-0069"},{"key":"e_1_3_2_13_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIE.2016.2530040"},{"key":"e_1_3_2_14_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIE.2012.2232253"},{"key":"e_1_3_2_15_2","doi-asserted-by":"publisher","DOI":"10.1109\/TASC.2018.2807377"},{"key":"e_1_3_2_16_2","doi-asserted-by":"publisher","DOI":"10.1109\/TEC.2016.2591925"},{"key":"e_1_3_2_17_2","doi-asserted-by":"publisher","DOI":"10.1109\/TASC.2016.2594863"},{"key":"e_1_3_2_18_2","doi-asserted-by":"publisher","DOI":"10.1108\/COMPEL-05-2018-0217"},{"key":"e_1_3_2_19_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIE.2016.2583409"},{"key":"e_1_3_2_20_2","doi-asserted-by":"publisher","DOI":"10.1016\/j.ymssp.2016.11.022"},{"key":"e_1_3_2_21_2","doi-asserted-by":"publisher","DOI":"10.1109\/TVT.2019.2913279"},{"key":"e_1_3_2_22_2","doi-asserted-by":"publisher","DOI":"10.1109\/TMECH.2012.2202123"},{"key":"e_1_3_2_23_2","doi-asserted-by":"publisher","DOI":"10.1109\/TPEL.2019.2933664"},{"key":"e_1_3_2_24_2","doi-asserted-by":"publisher","DOI":"10.1109\/TMAG.2015.2441035"},{"key":"e_1_3_2_25_2","doi-asserted-by":"publisher","DOI":"10.1109\/TMAG.2019.2904289"},{"key":"e_1_3_2_26_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIE.2018.2889628"},{"key":"e_1_3_2_27_2","doi-asserted-by":"publisher","DOI":"10.1109\/TMAG.2013.2242195"},{"key":"e_1_3_2_28_2","doi-asserted-by":"publisher","DOI":"10.1049\/el.2018.6273"},{"key":"e_1_3_2_29_2","doi-asserted-by":"publisher","DOI":"10.1016\/j.ymssp.2017.02.033"},{"key":"e_1_3_2_30_2","volume-title":"2011 international conference on electronic & mechanical engineering and information technology","author":"Cui J","unstructured":"Cui J, Liu J. A novel switched reluctance motor drive system. In: 2011 international conference on electronic & mechanical engineering and information technology, Harbin, China, 12\u201314 August 2011. New York: IEEE."},{"key":"e_1_3_2_31_2","doi-asserted-by":"publisher","DOI":"10.1108\/COMPEL-08-2017-0342"},{"key":"e_1_3_2_32_2","doi-asserted-by":"publisher","DOI":"10.1109\/TMECH.2018.2803148"},{"key":"e_1_3_2_33_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIE.2019.2892675"},{"key":"e_1_3_2_34_2","doi-asserted-by":"publisher","DOI":"10.1016\/j.compeleceng.2019.06.002"},{"key":"e_1_3_2_35_2","doi-asserted-by":"publisher","DOI":"10.1109\/TPEL.2013.2251475"},{"key":"e_1_3_2_36_2","doi-asserted-by":"publisher","DOI":"10.1515\/bpasts-2017-0091"},{"key":"e_1_3_2_37_2","doi-asserted-by":"publisher","DOI":"10.1109\/TMAG.2015.2443711"},{"key":"e_1_3_2_38_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIE.2017.2772204"},{"issue":"13","key":"e_1_3_2_39_2","doi-asserted-by":"crossref","first-page":"473","DOI":"10.1049\/joe.2018.0037","article-title":"Rotor position on-line estimation of aircraft brushless synchronous motor based on multi- stage-structure characteristics","volume":"2018","author":"Meng T","year":"2018","unstructured":"Meng T, Liu W, Jiao N, et al. Rotor position on-line estimation of aircraft brushless synchronous motor based on multi- stage-structure characteristics. J Eng 2018; 2018(13): 473\u2013477.","journal-title":"J Eng"},{"key":"e_1_3_2_40_2","doi-asserted-by":"publisher","DOI":"10.1109\/TIE.2010.2070782"},{"key":"e_1_3_2_41_2","doi-asserted-by":"publisher","DOI":"10.1109\/JESTPE.2020.2977957."},{"issue":"1","key":"e_1_3_2_42_2","first-page":"51","article-title":"Design and protection of the controller for SRD system","volume":"4","author":"Jiang X","year":"2006","unstructured":"Jiang X. Design and protection of the controller for SRD system. Micromotor Servo Tech 2006; 4(1): 51\u201356.","journal-title":"Micromotor Servo Tech"},{"key":"e_1_3_2_43_2","doi-asserted-by":"publisher","DOI":"10.1109\/ACCESS.2018.2888912"},{"key":"e_1_3_2_44_2","volume-title":"2011 second international conference on mechanic automation and control engineering","author":"Yan B","unstructured":"Yan B, Xu Y. Study of combined control strategies for switched reluctance motor. In: 2011 second international conference on mechanic automation and control engineering, Hohhot, China, 15\u201317 July 2011. New York: IEEE."}],"container-title":["Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering"],"original-title":[],"language":"en","link":[{"URL":"https:\/\/journals.sagepub.com\/doi\/pdf\/10.1177\/0959651820938945","content-type":"application\/pdf","content-version":"vor","intended-application":"text-mining"},{"URL":"https:\/\/journals.sagepub.com\/doi\/full-xml\/10.1177\/0959651820938945","content-type":"application\/xml","content-version":"vor","intended-application":"text-mining"},{"URL":"https:\/\/journals.sagepub.com\/doi\/pdf\/10.1177\/0959651820938945","content-type":"unspecified","content-version":"vor","intended-application":"similarity-checking"}],"deposited":{"date-parts":[[2026,5,1]],"date-time":"2026-05-01T22:39:29Z","timestamp":1777675169000},"score":1,"resource":{"primary":{"URL":"https:\/\/journals.sagepub.com\/doi\/10.1177\/0959651820938945"}},"subtitle":[],"short-title":[],"issued":{"date-parts":[[2020,7,15]]},"references-count":43,"journal-issue":{"issue":"9","published-print":{"date-parts":[[2020,10]]}},"alternative-id":["10.1177\/0959651820938945"],"URL":"https:\/\/doi.org\/10.1177\/0959651820938945","relation":{},"ISSN":["0959-6518","2041-3041"],"issn-type":[{"value":"0959-6518","type":"print"},{"value":"2041-3041","type":"electronic"}],"subject":[],"published":{"date-parts":[[2020,7,15]]}}}